Wheel list that fits over spoon calipers...
#154
Originally Posted by simonprelude,Oct 30 2008, 03:25 PM
Standard 16" NSX front wheels, no spacers required.
#156
Registered User
Join Date: Jul 2006
Location: On a rock wall somewhere...
Posts: 3,019
Likes: 0
Received 2 Likes
on
2 Posts
Volk GT-C 18x7.5+50 CLEAR, NO SPACER , but scary close!
I could fit a .025 inch feeler gague between there, but not a .032. My gague was old and not very good, but was a good enough indication.
I could fit a .025 inch feeler gague between there, but not a .032. My gague was old and not very good, but was a good enough indication.
#157
Registered User
Originally Posted by s2kadrenalin,Dec 3 2008, 10:38 PM
Anyone know if 17x8 +38 work meister S1 wheels will fit with spoons in behind them?
I know it'll stick out of the stock guards, but any suggestions other than a camber adj?
Any takers?
#160
Registered User
Join Date: Jan 2005
Location: Atlanta
Posts: 363
Likes: 0
Received 0 Likes
on
0 Posts
Not sure if anyone watches this thread any more but I'll ask anyway.
I've got CE28's 7.5" +50 offset (I think). Reading through the whole thread, apparently I'll need a 10mm spacer. Ok, I'm fine with that. However, I can't find a 10mm that is 70mm bore. I can find 5mm and 15mm, but no 10mm. Anyone know if this size exists? I'd probably be willing to run a 15mm, but I'm not sure that will then fit under my fenders. I'm even looking at getting some +10mm fenders to accommodate all this, but if I go +15mm spacer, I still might run out of room under there. I tried measuring, but tough to be certain, especially since I dont have the calipers yet (being shipped).
Honestly, I'm surprised I'll even need the 10mm spacer, doing my rough measuring makes it look like it will fit as is, so those calipers must be hella wide.
Anyway, where can I get a 10mm front spacer?
Thanks,
J
I've got CE28's 7.5" +50 offset (I think). Reading through the whole thread, apparently I'll need a 10mm spacer. Ok, I'm fine with that. However, I can't find a 10mm that is 70mm bore. I can find 5mm and 15mm, but no 10mm. Anyone know if this size exists? I'd probably be willing to run a 15mm, but I'm not sure that will then fit under my fenders. I'm even looking at getting some +10mm fenders to accommodate all this, but if I go +15mm spacer, I still might run out of room under there. I tried measuring, but tough to be certain, especially since I dont have the calipers yet (being shipped).
Honestly, I'm surprised I'll even need the 10mm spacer, doing my rough measuring makes it look like it will fit as is, so those calipers must be hella wide.
Anyway, where can I get a 10mm front spacer?
Thanks,
J