koukikat

Can anyone who has a set of AP2 v2 wheels laying around please take pics of the backpad for the front and rears for me (inside of the wheel where the wheel presses and seats against the rotor). I am looking to compare the backpad to my AP1 wheels, specifically the depth of the indentations between the stud holes. Thank you very much!
-Sean

koukikat

Anyone?? I know there's like 3 sets in th FS section. Just a quick pic of the inside of the wheel please.

R1_Pilot

Give me like 30 minutes and I will snap some pictures. Anything that you wnat me to measure? I have a caliper here.

J

koukikat

You're ****ing awesome, thanks!
I'm interested in the depth of the indentations between the studs, concerning OEM stud clearence when running bolt on spacers with the AP2 wheels.
Again, thanks!
-Sean

R1_Pilot

Sean,

See pics below. I will go and measure the indentations in a bit as I took the pictures before I saw your reply.

Rear wheel




Front wheel




I will measure that in a sec. J

R1_Pilot

You have roughly 12mm or 1/2" of depth on those pockets.
Hope this helps.

J

koukikat

That is the EXACT info I needed, I really appreciate that.
Thanks again.... and if anytime you find yourself in the state of Maine I owe you a beer!