Mugen MF10 back in production!
05-03-2017 | 01:04 PM
#141
Joined: Mar 2014
Posts: 734
Likes: 60
From: San Diego
i'm not sure what wheel will fit a BBK and allow you to leave your front fenders unmolested....maybe a 17x8 +45 RPF1 but you might need to run some camber and a smaller tire. To leave your front fenders unmodified, you'd probably have to run a 7", 7.5" or 8" wide wheel and there aren't many wheels that have a lot of brake clearance in those sizes with the right offsets.
Of course, these are peasant wheels compared to the MF10s, but they're light and do exist
05-08-2017 | 06:12 AM
#143
Site Moderator
Joined: Jul 2005
Posts: 48,997
Likes: 2,903
From: Michigan
05-16-2017 | 06:54 PM
#147
Joined: Sep 2006
Posts: 7,642
Likes: 95
From: Irvine
i think these wheels will be with the car until it's sold! the only way i could see changing it up is if i got a wide body kit but that has about 1% chance of happening at this point haha.
05-22-2017 | 07:12 AM
#148
Joined: Sep 2008
Posts: 52
Likes: 1
From: Portugal
Chris, did you buy center caps to go with the wheels? Are yours in good condition? Mine are missing paint around the center screw, which is frustrating.
The MF10s have a pretty good finish, thank goodness. I see yours have the same little dots on the inner barrel as mine. Must be where they held the wheel to finish it. Mine are also missing a little coating near the surface that contacts the wheel hub, and have small forging imperfections (uneven surface) near a couple of the lug holes.
The MF10s have a pretty good finish, thank goodness. I see yours have the same little dots on the inner barrel as mine. Must be where they held the wheel to finish it. Mine are also missing a little coating near the surface that contacts the wheel hub, and have small forging imperfections (uneven surface) near a couple of the lug holes.
05-22-2017 | 08:31 AM
#149
Joined: Sep 2006
Posts: 7,642
Likes: 95
From: Irvine
Chris, did you buy center caps to go with the wheels? Are yours in good condition? Mine are missing paint around the center screw, which is frustrating.
The MF10s have a pretty good finish, thank goodness. I see yours have the same little dots on the inner barrel as mine. Must be where they held the wheel to finish it. Mine are also missing a little coating near the surface that contacts the wheel hub, and have small forging imperfections (uneven surface) near a couple of the lug holes.
The MF10s have a pretty good finish, thank goodness. I see yours have the same little dots on the inner barrel as mine. Must be where they held the wheel to finish it. Mine are also missing a little coating near the surface that contacts the wheel hub, and have small forging imperfections (uneven surface) near a couple of the lug holes.