mark_k

Hi Si,

Could you give me a price for a black passenger side tweeter cover grill thing for a MY06? I can't see them on your website.

Thanks
Mark

rnibleck

Ey up si

Could ye price me on the stat that goes in bottom of rad, main engine thermostat all the boot trim clips and all the clips for the plastics where the roof folds into.

Cheers fella

Tom

MattyH

Morning Si,

The engine is finally out and they've found the problem which was the main bearing and the some dubious big ends, could I get a price for the following please?

Full set (5) of crankshaft main bearings
full set (4) of big end bearings
1 x knock sensor
1 x crank pulley bolt


Thanks very much!

Si@Hendy Performance

Hi Mark,

Sorry busy weekend at Thruxton - bit behind with PM's and forums.

We don't have a large call for these so they are not on the site - but I can add them if more people want them.

For the time being.

Please paypal eshop@hendy-group.com with the price and part number below.

Part number 83551-S2A-J51ZB £55 inc delivery (these are for a Black Interior)


Ok

The Honda Thermos witch and Stat will be £128 inclusive of delivery.

After market will be cheaper - IE Spoon/Mugen (see our website).

I think the clips you need are 91505-ST7-003ZA x 3 on the system

Total comes to £135.99 inc delivery if you opt for the Genuine Honda ones above - REF 37329.


Hi Matty - these bearings are not that easy!

They are colour coded with different sizes for both the crank and big ends. The knock sensor and crank pullet bolt are simple.

Bets to email us through the website then we can reply with better info, images etc.

Si

MattyH

Thanks, I've emailed you on both the performance parts and eshop address.

Si@Hendy Performance

You should of had a reply that I sent just before leaving the office

rnibleck

Ey up, I have had a gander on the site and can only see the spoon thermostat which is dearer than the standard Honda one.

I presume I'm being blind, but can ye price us for the spoon thermostat and rad stat/switch?

With regards to the clips, I think I will need more than 3.

Cheers

Tom

Si@Hendy Performance

Hi Tom!

Drop an email over and we can sort these pesky clips out with the aid of some diagrams as then ones I found on the rear shelf (honda's name!) just stated 3.

I'll sort something on the thermostat and switch at the same time.

Si

GreenmanS2000

Si

Just paypal'd £7 for a new seal for the oil filler cap (S2000 obviously)

Thanks

Si@Hendy Performance

Thanks Clive - we will get it ordered tomorrow!

Si