Genuine Honda Parts Thread
#2772
UK Trader
Thread Starter
I think you mean the moulding/trim that sits between the glass and the door panel on the outside of the car?
Just set up on the site:-
http://www.hendyeshop.co.uk/molding-...13-63998-p.asp
#2773
Originally Posted by japcrap' timestamp='1428570823' post='23571950
Hi Si, hope you are well. Can you provide me a link to the fixings that are used to secure the front bumper along the chin. Bodyshop forgot to put some back in and are asking me to provide a link to the parts...
Only image I have to hand is here - but the install manual in the box will be better than that - I'm afraid I don't have any lips on the shelf or due in at the moment, but that may change once I trawl through all the emails I have piled up!!
I just mean the fixings that hold the floor to the front bumper I believe. The ones that run around the front lowest edge of the bumper. My car doesn't have a lip fitted...
#2774
UK Trader
Thread Starter
Ok - the front bumper is just normally 7 push clips and 4 bolts on most hondas. I took my FD2 one off on Tuesday to remove the resonator chamber (not fun) to fit my new airbox.
The diagrams are quite poor and do not really show where things go. I think I have a workshop manual at home on a PDF somewhere.
The diagrams are quite poor and do not really show where things go. I think I have a workshop manual at home on a PDF somewhere.
#2775
Ok - the front bumper is just normally 7 push clips and 4 bolts on most hondas. I took my FD2 one off on Tuesday to remove the resonator chamber (not fun) to fit my new airbox.
The diagrams are quite poor and do not really show where things go. I think I have a workshop manual at home on a PDF somewhere.
The diagrams are quite poor and do not really show where things go. I think I have a workshop manual at home on a PDF somewhere.
#2776
UK Trader
Thread Starter
Yes
The side screws (into the upper wings) - 90109SS0000 (max req 2)
The bumper clips (push fit) - 91503SZ3003 (max req 12)
Do you need the bolts also as I will need to set them up?
The side screws (into the upper wings) - 90109SS0000 (max req 2)
The bumper clips (push fit) - 91503SZ3003 (max req 12)
Do you need the bolts also as I will need to set them up?
#2777
Si, I need the OEM fixings that are in the first picture of this thread -
https://www.s2ki.com/s2000/topic/110...per-protector/
Please put them on the site. Cheers.
https://www.s2ki.com/s2000/topic/110...per-protector/
Please put them on the site. Cheers.
#2778
UK Trader
Thread Starter
Si, I need the OEM fixings that are in the first picture of this thread -
https://www.s2ki.com/...mper-protector/
Please put them on the site. Cheers.
https://www.s2ki.com/...mper-protector/
Please put them on the site. Cheers.
I think these should do the trick.