Mark this thread as Unsold
Rear tie bar/ subframe brace
#2
If you're not after any bling factor, you can buy a length of alu bar, drill some holes and bolt it on for the same effect and probably even cheaper than a 2nd hand one. A few of us have done it with a noticeable improvement.
#3
Yep, a bit of 3/4 x 1 1/2 inch Ali bar , you don't need more than a metre . Look for a local non ferrous metal stock holder
You need 4 10mm x 1.25mm pitch bolts about 40mm long and 2 longer M6 bolts
Take the OEM one off and use it as a template to drill the 6 holes ,or some where on here is a drawing posted years ago
Works a treat
You need 4 10mm x 1.25mm pitch bolts about 40mm long and 2 longer M6 bolts
Take the OEM one off and use it as a template to drill the 6 holes ,or some where on here is a drawing posted years ago
Works a treat
Thread
Thread Starter
Forum
Replies
Last Post
turbo8765
S2000 Racing and Competition
3
08-04-2013 05:45 PM
travanx
S2000 Modifications and Parts
4
09-18-2009 04:15 PM