Problematic CEL relating to primary O2
#1
Registered User
Thread Starter
Problematic CEL relating to primary O2
On Saturday just gone I had a temporary issue where when pulling away the car was labouring and almost stalling, at this point I had no engine management light on. I stopped for a moment to check I was actually in the right gear, let it idle for a couple of minutes and tried again. It been fine since.
Tonight after being parked for a couple of hours, the engine management light came on after a little while.
The only symptom I'm getting is the car is almost stalling at idle, even when warmed up. I'm guessing this points to a sensor but I'm not sure which?
Has anyone got any suggestions?
Tonight after being parked for a couple of hours, the engine management light came on after a little while.
The only symptom I'm getting is the car is almost stalling at idle, even when warmed up. I'm guessing this points to a sensor but I'm not sure which?
Has anyone got any suggestions?
#2
Code reader.
#4
Registered User
Thread Starter
I had a brainwave, there's someone local (like one street over) to me who has one!
Hopefully it's nothing serious as I have no choice but to drive my car as I need it for work.
Hopefully it's nothing serious as I have no choice but to drive my car as I need it for work.
#6
Registered User
Thread Starter
Will it clear once the sensor (assuming its that) has been replaced?
Does anyone use a bluetooth OBD2 reader with Torque? eBay is full of millions of them.
Does anyone use a bluetooth OBD2 reader with Torque? eBay is full of millions of them.