markforrester99

I have vibratec engine mounts and they don't have alignment marks on them so when fitting its a case of getting them as close to OEM positioning as you can by eye which might explain why my engine might be further over.

E4RTH WORM JIM

Do you get any horrible vibrations with these mounts?

markforrester99

No they are much much better than the Megan mounts i had before. Just annoying that you have to do some guessing when fitting. I took the brackets off of the block on either side, fitted the mount to the bracket and then reassembled. Got there in the end.

Trunkz

I'm pretty sure I've got spoon engine mounts on mine (as well as the spoon gearbox mount). I'll try and take a picture next time I'm under the car.

On a sidenote - where can I buy those pesky honda trim clips? I basically broke them off when removing my wheel liner.. Found on eBay. Bag of 9mm clips for under £3. Beautiful.

johnckeen

Dont go to honda for those clips... they wanted £38 for a dozen... i laughed and walked out.

I have the standard oil cooler, sandwich plate and standard filter installed, the pipe rests on the oil filter but it doesnt matter as you can just take he back pipe off and you can change the filter...

Define198

i purchased a full set of them from ebay, which contained all the different sizes required for the full bumper and both arch liners

Plastic Trim Clip Kit for Honda S2000- Full Set of Wheel Arch & Undertray Clips | eBay

I now have plenty of spares for the future, well worth the investment!

Toms1989

Good find that. Just bought some now

johnckeen

Does it have the plastic screw in ones for the air duct behind bumper?

Define198

from memory i dont think it did, it did have the bumper to wing plastic block things that the single screws go into under the arch

E4RTH WORM JIM

:thumbuo:

Have you sorted your W/Meth issues?