vadhert

How do you replace the small lights inside the panel?

Is it a PITA?

s2konroids

You'll have to remove the whole dash mate

Similar to when you replace the starter button light.

loftust

It's fiddly...Squeak has a dodgy lamp in there too

Remove the ignition barrel covers
Lowering the steering column
Pull the dash surround off, by getting your fingers in the gaps and pulling towards you
Disconnect the electrical connectors on both sides
Remove the dash surround
Take a look and find that lamp

Qube's website has instructions with pictures for all of the above...except checking for the blown lamp

RedUn

Typical S2000 - I'm sure the Japs designed like a jig saw what interlocks so to get to a middle piece you have take all the rest out!

The Loon

anyone know what bulbs are needed? I have a blown bulb in the heater control unit and another one in the audio control module that need to be replaced

loftust

Have a look in Squeak's Qube Thread...I'm sure Fester posted up a US site that sells LEDs and are the correct fitment for the dash...go the whole hog, replace them all, and choose your own colour at the same time

RobinA3

my heater light is a bit dodgy, have to give it a 'tap' and it comes on, too much hassle removing the dash to change it so its going to have stay not working!

loftust

20 minute job in all...seriously

J_D

as above, mine went out and i gave it a bang and it came back on again

The Loon

Tried that - no joy.