The big "quest for more power" thread
#723
Registered User
Join Date: Oct 2005
Location: ||-|| (()) ||\|| ||)) //\
Posts: 2,692
Likes: 0
Received 0 Likes
on
0 Posts
The new ivtec thing should be good for torque, reliability at high rpms could be an issue though...
Also matched with a proper header and an intake manifold if not ITBs. Also some headwork (see endyn) should be very good on the top of that. In case the ivtec thing fails, cam gears could do the job.
Also matched with a proper header and an intake manifold if not ITBs. Also some headwork (see endyn) should be very good on the top of that. In case the ivtec thing fails, cam gears could do the job.
#724
Registered User
Join Date: May 2005
Location: Sussex
Posts: 1,947
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by E4RTH WORM JIM,Dec 10 2009, 11:03 PM
Good bump. I haven't seen this thread for a while.
I've got plans for next year
I've got plans for next year
Razzelle have a look at the gauges Vadhert has for sale on the board. The PLX ones are very good.
#725
VAFC2 learning myth: still hasnt been learned over (in WOT of course, with no adjustments to partial throttle).
I'm finishing off my snorkle to block off heat from the rad to the k&n and using some filler to finish it off/make it look nicer.
I'm finishing off my snorkle to block off heat from the rad to the k&n and using some filler to finish it off/make it look nicer.
#726
Originally Posted by razzele,Dec 10 2009, 11:56 PM
Im going for a little air pump on a new engine with a decat and full system to complete, still looking for gauges to monitor boost/afr/oil t&p.
Any gauge suggestions?
Any gauge suggestions?
Theres an all in one guage cant remember the name though.
Thread
Thread Starter
Forum
Replies
Last Post