Slows2k

I'm trying to lighten the load to pack up and move with the rest of the household, and I can deliver if the parts will fit in a S2k All parts are OBO, unreasonable offers will still be entertained


Here is the list:
ELDA roll bar, freshly powdercoated matte black. May need a few bolts for install. $500

AP1 cylinder head, aprrox. 5-6K miles on a turbo motor. Was a bare OEM head built with REV valves and springs and retainers. Would recommend having the valves and seats reground. SOLD

AP2 (04) cylinder head. Used less than 2K miles. All stock and ready to run. $ 600

AP2 (06) camshafts, brand new still in plastic. $200

AP1 MY00 Front sway bar SOLD

AP1 Starter Used, approx 36k $80

AP1 Alternator Used, approx 36K $80

AP1 axles, left and right. Used approx 36K. SOLD

AP1 passenger side Airbag $150

AP1 seat belt retractors $25 each

FJO wideband 02 sensor and gauge $100

RC engineering 850cc low impedance injectors, these require a resistor box or injector driver. Resistor box included. $150

Autometer Electronic boost gauge. Carbon face 52mm $70

Turbonetics 60-1 Hi-Fi $300

Slows2k

Axles here, Propshaft is gone


AP2 cams


AP2 Head


FJO wideband


RC Injectors


60-1 turbo

Slows2k

Cell phone pic of rollbar.. I had it re powdercoated, but did not install it. I' have the harness bar and diagonal, both coated matte black as well.




Looks like this installed.

silverstone55

SENT YOU A PM

Slows2k

AP1 head and Turbo sold.

Beezy.

I need those axles bad!

Slows2k

I'll be up there in another week. If they fit in the car I can bring them.

Beezy.

Wrd.
How much for those red seats?

Slows2k

Seats have been gone for months. TwoR's in B-ham got them when the gray car was totaled.

Slows2k

AP1 sway bar is gone too