Track car labour of love build thread - Clubhopper
The following users liked this post:
jonnyrotten (05-02-2024)
#252
been a while and been quite occupied from updates but here is a big dump.
New VIN plate made by snisen
Acuity Shift boot collar installed
Went back to stock exhaust with Ap2 tips. AP2 tips stick out way too much so I need to cut it down.
EVS Rear Toe kit installed
Went for a cruise up north.
Took the car out a lot this season which is a good thing.
New VIN plate made by snisen
Acuity Shift boot collar installed
Went back to stock exhaust with Ap2 tips. AP2 tips stick out way too much so I need to cut it down.
EVS Rear Toe kit installed
Went for a cruise up north.
Took the car out a lot this season which is a good thing.
#253
Decided to gather up some parts taking up room and build a diff. Weir solid collar, 4.44 Mazda gear set, Powerneedy bearing caps, arp hardware, greddy v2 oil cover, OSGiken 1.5 way Sspec LSD. Brand new oem bearings.
Spec’d out nice and gear pattern looked great.
Overnight parts from Japan
Advan RZ-F2 Forged in Umber Racing Bronze 18x10 +35 square
Quick check
Ppf’ing barrel stickers. Started doing this to all my wheels now.
#254
Annual 2024 Niagara Cruise
Tires mounted and balanced on advans. Advan AD09 265/35-18
Ceramic coating commenced for both wheel and tire combo.
Finally on.
I love bronze on red. These wheels are light at 18.9 lbs so weighed nothing.
Had to clearance the overfenders and fenders a bit.
Vaughan night meets.
Advan center caps arrived also in bronze.
Yo dawg I heard you like advans. So I got advans for your advans for your advans.
Morning drives for coffee
Complete for now.
#255
Pulled the trigger this season on a 8/10 condition. Original paint BB hardtop to try the 2 tone look.
Had a couple dents on it pushed out to bring it close to 9.5/10. I drove to the pdr guy with no plastics or liner to make it easier as everything is discontinued and if someone is breaking something then I rather it be me lol.
All done and I’m really digging the 2-tone
Sunrise
Installing set screws in prep for Baero front upper arm offset bushings.
Get in your home!
Pressing them in.
Pulls the top in about 7mm for more static camber. Looking forward to adding a bit more camber for runs and track use.
Put this off for a while but I replaced the coil pack plugs as a couple of them had broken locking tabs. Did spark plugs while I was at it too.
The following users liked this post:
S2K Type R (08-29-2024)
Thread
Thread Starter
Forum
Replies
Last Post
Curated Content Editor
S2000 Talk
1
11-16-2018 09:48 AM