Lionheart

Hello,

I was trying to install my GPS into the car, but I find some changes in the ECM A 32P connector for the VSS. This is how it is supposed to be on the MY00-03...

P1 : yel/grn
P2 : red
P3 : orn
P4 : lt grn/wht
...
P9 : blu/wht = VSS

But I have...

P11 : yel/grn
P10 : red
P9 : /
...

The cable is almost like it should be, except that I can see 11 printed (upper left) on the connector where the 'yel/grn' is (should be 1), so at the 10 position I have the 'red' (should be 2) etc... The P3 and 4 (9 and 8 following the numbering on my cable) are not connected, so no 'orn' and no 'lt grn/wht'. When the 11 and 1 mark would be swapped on the connector, it would come close, except for the 'orn' and 'lt grn/wht' that I do not have. At 9, I have the 'blu/wht'... Is it the VSS? Thanks for any info...