valvoline tranny fluid
#3
Registered User
Thread Starter
http://www.valvoline.com/products/commerci...nd-gear-oils/78
I hope this copy/paste right add. Sorry using a phone isn't that help.
It says heavy duty tranny fluid.
Thanks.
I hope this copy/paste right add. Sorry using a phone isn't that help.
It says heavy duty tranny fluid.
Thanks.
#4
Registered User
If their SAE 50 grade is gear oil viscosity, then it will be too thin. If it is engine oil viscosity, then it will be too thick. I wouldn't try it in the S2000.
#6
Originally Posted by INDYMAC,Oct 19 2010, 06:53 AM
If their SAE 50 grade is gear oil viscosity, then it will be too thin. If it is engine oil viscosity, then it will be too thick. I wouldn't try it in the S2000.
Why not use Honda MTF? It's good stuff and cheap.
Trending Topics
#8
Registered User
Thread Starter
OEM MTF didn't give me suprise, i tried and was ok. i put pennzoil SM few months back and it feels like already shot out. I prob go with GMSMFM at this time.
#9
Registered User
Join Date: Jan 2006
Location: 17 ft below sea level.
Posts: 4,949
Likes: 0
Received 21 Likes
on
16 Posts
If your MY05 really shifts that bad I would look into properly bleeding the clutch hydraulics, greasing the fork & push rod and checking the free play of the linkage.
Also, it could be the clutch disk is - after 5 years of collecting clutch dust and some rust (yes it does happen) - not able to slide over the splines that well anymore, creating crunchy shifts.
Not much to do about that with the trans installed though
Amsoil MTF works for me.. btw.
Also, it could be the clutch disk is - after 5 years of collecting clutch dust and some rust (yes it does happen) - not able to slide over the splines that well anymore, creating crunchy shifts.
Not much to do about that with the trans installed though
Amsoil MTF works for me.. btw.