Valve Adjustment Mistake
#21
Better than being accidentally run way too tight, I'd imagine
#22
#23
Not sure where you got those clearance specs from but not even close. Have a peek at this thread from Billman.
https://www.s2ki.com/forums/s2000-un...2A%2A-1060900/
https://www.s2ki.com/forums/s2000-un...2A%2A-1060900/
If you read the fine print it tells you the valve clearance under the hood. However it's in mm.
#24
Dipstick from top of measurement area to bottom of measurement area is a quart, so if you've got no oil on the dipstick at all you're probably at least a quart and a half low.
#25
Dipstick reads zero oil and they assume engine has no oil.
#28
Same thing happened to me after I did my first VA in my S. I had forgotten to plug a wire back in on the front below the cover - might have been the one that gets in the way when you are changing the oil filter? Not sure. But I was changing the oil and filter at the same time. I plugged it back in - light was gone.
#29
I agree on a missed connector, but grab one of the wireless OBD2 dongles off Amazon for $15 bucks and a free app for your phone so you can pull codes in the future.
#30