About to take the flywheel to the machine shop. Does anyone have the specs for the factory AP1 flywheel as far as minimum thickness and things. Thanks

 

i looked in my shop manual and couldnt find anything.. it just says resurfacing is not recommended. i have the tolerance for the runout though.

 

Machining is not recommended so normally tolerances will not be published. I would think that taking off as little as possible to get a good surface would be the procedure.

 

I haven't gotten a good look at it yet but from what I remember there aren't any dark spots or scratches-blemishes on it. The car has 61xxx miles on it so I am thinking it will be alright. I will take it to the shop to have them run the straight edge over it just to see.

 

If it is that good I would just sand the surface with #100 sandpaper without even pulling it and call it good.