Tanabe Strut Brace
06-04-2005, 01:07 PM
#1
Registered User
Thread Starter
Join Date: Apr 2005
Location: Lighthouse Point
Posts: 188
Likes: 0
Received 0 Likes
on
0 Posts
Tanabe Strut Brace
I am putting in a Tanabe Sustec strut brace and have a K&N FIPK gen II intake.
Not sure which direction the strut brace goes.
I can mount it to the inside of the towers in which case it sits about 1/4" in front of the block and rubs the intake where it mounts to the throttle body. The rubber / silicon joiner.
If I mount it so it sits in front of the towers then the K&N intake interfers and rubs.
The directions were in Japanese - not legible to me.
Anyone mount one of these and which option did you choose ???
Not sure which direction the strut brace goes.
I can mount it to the inside of the towers in which case it sits about 1/4" in front of the block and rubs the intake where it mounts to the throttle body. The rubber / silicon joiner.
If I mount it so it sits in front of the towers then the K&N intake interfers and rubs.
The directions were in Japanese - not legible to me.
Anyone mount one of these and which option did you choose ???
Thread
Thread Starter
Forum
Replies
Last Post