Spun at Infineon T6 and now ABS won't work
#11
Thread Starter
I (well, my son) drove the car a mile home from where my trailer's stored. No ABS light. Checked ABS DTC codes by shorting OBDII pins 4&9. Codes 12, 15, 17 and 61 were stored. Took it for a short drive and the ABS worked fine. Cleared the codes and tested ABS again, worked fine and no codes. I guess all is well.
Since the car never stalled in the spin, the ABS remained disabled when I went back out from my required hot pit scolding. Even though the ABS system was fine, the system wasn't reset by turning off-and-on the ignition. That's why I locked up the brakes going into Turn #4 (well, that and poor braking skills ;-). When I went back to the paddock I should have driven the car >19mph after turning the ignition off.
Nice to know the S2000 remains pretty resilient!
Since the car never stalled in the spin, the ABS remained disabled when I went back out from my required hot pit scolding. Even though the ABS system was fine, the system wasn't reset by turning off-and-on the ignition. That's why I locked up the brakes going into Turn #4 (well, that and poor braking skills ;-). When I went back to the paddock I should have driven the car >19mph after turning the ignition off.
Nice to know the S2000 remains pretty resilient!
Thread
Thread Starter
Forum
Replies
Last Post