bubsie007

I recently installed a Autometer Digital Pro Shift Light that's installed into my gauge pod, and for some reason the RPM's are reading about 100 - 200 RPM's off. The autometer gauge reads lower than my RPM gauge, I was wondering if this is normal or if something is wrong, any help would be greatly appreciated.

BTW I took signal from the blue wire at the ECM right by the clutch pedal following mordifry's install.

rob-2

My gauge shows about 1k but a reader suggests it's about 850.

bubsie007

oh okay thanks, so i'm assuming that's normal. I'm off by about the same amount and same thing, my cluster reads higher than the gauge