Removing thread locked bolt
#1
Registered User
Thread Starter
Join Date: Jun 2007
Location: Perth, Western Australia
Posts: 927
Likes: 0
Received 0 Likes
on
0 Posts
Removing thread locked bolt
I need help removing thread locked bolt from my PWJDM Intake.
I tried removing it using allen key but it just didn't move and if I force it, I might just strip the bolt.
Can any of you guys help me?
Thanks in advance
Erik
I tried removing it using allen key but it just didn't move and if I force it, I might just strip the bolt.
Can any of you guys help me?
Thanks in advance
Erik
#2
Registered User
Join Date: Nov 2008
Location: Brit in Athens, Greece
Posts: 1,797
Likes: 0
Received 0 Likes
on
0 Posts
You need heat, and lots of it. Threadlock is rated based on how much heat it can take and stay bonded. Depending on the size of the bolt and type of threadlock (blue/red?) will determine how hot a heat source you need. Most red threadlocked bolts can be done with a small pentorch. It may also help to dremel a groove in the head so you can use a flat blade screwdriver for more worry-free leverage. Of course you will then need to replace the bolt.
#5
Registered User
Join Date: Nov 2008
Location: Brit in Athens, Greece
Posts: 1,797
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Gigdy,Oct 8 2009, 02:54 PM
A thread locked allen bolt sounds like a terrible idea.
#6
Registered User
Threadlock on an exhaust? Doesn't sound right. Loctite melts at a pretty low temp. It may just be seized, or a locking nut. An impact bit and a low torque impact is your best bet.
Trending Topics
#8
Join Date: Nov 2007
Location: Illnoise. WAY downtown, jerky.
Posts: 8,374
Received 1,393 Likes
on
1,039 Posts
well then he can't really heat it without damaging the intake itself. It has a resin on it.
Can you heat it from the bottom without touching the intake with the torch?
Can you heat it from the bottom without touching the intake with the torch?
#10
Can you use vicegrips to grab the outside of the bolt. If not try shocking it off with a allen key, and if you stuff it use a mig welder to weld an old bolt onto the end of the bolt. Gives you something solid to grab it with, and some heat to loosen the bolt.