Ramps for low profile cars like the S2K
#1
Registered User
Thread Starter
Ramps for low profile cars like the S2K
I really like the low profile 11 degree race ramps but Lordy they are expensive! Do the higher ramps like 17 degree work on a stock height S2K? Any recommendations/feedback is appreciated!
The following users liked this post:
jackmugen02 (01-29-2021)
#3
Whatever you use, be sure to measure from ground to your pinch welds in the back, as the rear ramps will need to fit under there. I believe on a stock S2k that is about 4.5 - 4.75 inches (but measure yours to be sure) so that is the tallest ramp you can use if putting all 4 corners on ramps.
I have race ramps, but just the shorty ones for helping get a jack under the car (mine is lowered about an inch).
I have race ramps, but just the shorty ones for helping get a jack under the car (mine is lowered about an inch).
The following users liked this post:
mavric (01-29-2021)
#4
Join Date: Aug 2012
Location: Foothills East of Sacramento
Posts: 5,850
Received 1,716 Likes
on
1,023 Posts
I have some angle cut 4X6s that I can drive up on to help get a little more room for ramps and jacks.
#5
Rob (ralper) over in the vintage section devised a really good setup for his S I'll see if I can find it for you.
Thread
Thread Starter
Forum
Replies
Last Post