riokong

I might have been a little too careful thats why it took me soo long but in the end I am very happy with it and got good gains from it and didn't need to spend over $1000. Just drill a little hole and plus it's got a carb # on it already! No questions from You know who.





OEM Dyno...



Injen Dyno...

Tyraid2K

very clean, looks sharp

harrrrry

..that's....it?

just drill a hole for the temp sensor?

gomarlins3

The '06 doesn't seem to have the same hose set up as the AP1's. Your's looks a little cleaner.

s2k dre

i was lookin at that too, it looks slightly different from my 04.

mic_crispy

How far apart where the dynos? and where they done on the same dyno?

riokong

Yep that and pluging the hole coming out the back of the elbow is the only mod you will have to do different from the earlier models. I saw the AEM V2 and it's the same too. The 06's don't even have vacum and exhuast lines to replace and no secondary bolt up top as you can see to mount the top section of the elbow but it's still very stable. The Intake doesn't move at all very secure.

riokong

Yeah on the same dyno! I think it was 8 months apart.

s2k dre

does the 06 have a throttle cable still?