MESSED UP CLUTCH HARD LINE TO MASTER CYLINDER
#1
Registered User
Thread Starter
MESSED UP CLUTCH HARD LINE TO MASTER CYLINDER
i'm currently replacing my clutch master cylinder with the Omni Quicklutch master cylinder. i was (stupidly) not using a crow's foot to remove the bolt holding the hard line to the clutch master cylinder (made of some softer metal), so the part of the bolt that the wrench grips on to is now stretched/deformed/rounded. i can't even get it off with a grip...
what should i do? should i just wait until i can get a new hard line??
thanks
what should i do? should i just wait until i can get a new hard line??
thanks
#6
Originally Posted by nightcrawler7188,Jan 14 2008, 03:24 AM
yea that's my next step. but i gotta go to the store to get one tomorrow
#7
Registered User
Thread Starter
MC installed. now i have another problem. i can't get any fluid to come out of the bleeder valve. the fluid level isn't going down at all, and i can't get it to come through. and there's no pressure in the pedal at all. so i don't know what the problem could be.
Trending Topics
#9
Registered User
Thread Starter
#10
Registered User
Thread Starter
Originally Posted by 2poor2mod,Jan 15 2008, 09:16 PM
if you need the new line check out this website
http://www.hondaautomotiveparts.com/auto/j...MASTER+CYLINDER
http://www.hondaautomotiveparts.com/auto/j...MASTER+CYLINDER