MES service connector (SRS light)
10-05-2011, 08:50 AM
#54
Registered User
Thread Starter
Join Date: Jun 2011
Location: Encinitas
Posts: 412
Likes: 0
Received 0 Likes
on
0 Posts
I knew the SRS light was, i just didnt know the extent to why. technically it was my fault, and i learned my lesson big time. Im just trying to make it right.
10-27-2011, 11:19 AM
#55
Registered User
Thread Starter
Join Date: Jun 2011
Location: Encinitas
Posts: 412
Likes: 0
Received 0 Likes
on
0 Posts
bumping this. I installed just the connector of the new seatbelt tensioner and the code still will not clear!! ANYONE??? desperate at this point.
Snap on scanner blinked manual codes through EPS light, however EPS light is not on. the 2 codes that were shown through the EPS light were 3-2 and 3-5 . which are short to ground and high resistance in driver seatbelt tensioner. (translated as SRS not EPS)
I perform the SRS light reset procedure and it works all the way until the last step.
#7. The SRS indicator light will blink two times indicating that the memory has been erased.
It blinks once then comes back on. Now does this mean theres still a problem or i am not clearing correctly?
Any help would be appreciated. thanks.
Snap on scanner blinked manual codes through EPS light, however EPS light is not on. the 2 codes that were shown through the EPS light were 3-2 and 3-5 . which are short to ground and high resistance in driver seatbelt tensioner. (translated as SRS not EPS)
I perform the SRS light reset procedure and it works all the way until the last step.
#7. The SRS indicator light will blink two times indicating that the memory has been erased.
It blinks once then comes back on. Now does this mean theres still a problem or i am not clearing correctly?
Any help would be appreciated. thanks.
11-11-2011, 01:07 PM
#59
Registered User
Thread Starter
Join Date: Jun 2011
Location: Encinitas
Posts: 412
Likes: 0
Received 0 Likes
on
0 Posts
