st_rage

I bought a Grizzly low profile jack. It weighs a ton, 108lb to be exact, and doesn't quite reach the front jack point. The shipping costs make it essentially unreturnable, so I'm weighing my options.

Option one: trim it down with a plasma torch to fit. I think this will work, but I need to make a couple of measurements.

Option two: sell it on craigslist and pick up another jack. Which leads me to my question-> is there a good jack out there that will reach the front jack point?

Here's the jack:
http://www.grizzly.com/products/2-5-Ton-Lo...rage-Jack/H8093

RadioZero

www.tooltopia.com is your friend.

st_rage

It is indeed, but Tooltopia doesn't tell you if it can reach the front jack point of an S2000. The omega (the only one that looks like it might) won't.

I've already searched here, and pretty much everyone seems to use some 2x4's and a cheapie jack.

Ubetit

^ Who told you that?

I have the Omega and it hits the front jacking point with no problem.



I was lowered 1.3 inches with a lip and splitter also

Emil St-Hilaire

Very nice piece,Ubi.
Where did you get that,and how much ???

-Emil.

Ubetit

It was on sale with free shipping when i bought mine. I think it was $225, but I'm not sure.

http://www.tooltopia.com/index.asp?PageAct...OD&ProdID=11737

RadioZero

the Omega has no problem hitting the front and rear center jack points.

Ubetit

I can't remember where I got this.

st_rage

If you say it works, I believe you.

I was going off of this :

http://forums.corvetteforum.com/show....php?t=1814892

It shows the hump starting at 25". I had measured 28" from the lip to the center of the jacking point.

[edit: it's same link as your pic. You slipped your post in somehow.]

WlSEGUY

I do to have omega jack.
it clears al the jack point except the front sub-frame jack point.
my car is pretty low.