issue after hondata img install...
#11
Former Moderator
While the intake manifold was off the car, did you try to clean it? If so, did you leave the IAC in place? If yes to both, then it's likely you have a sticking IAC. All the crud you tried to clean out, ended up in the IAC.
#12
I had a similar situation when I installed my Hondata gasket (yes, a royal PITA). During the install, I also removed the MAP sensor to clean its port but didn't realize the o-ring fell off before reinstalling it. I had large idle fluctuations and a smoke filled garage. I moved the vehicle out of the garage and found the o-ring on the floor. Once the o-ring was back in place, the engine ran perfectly.
Did you remove the MAP sensor during your install?
Did you remove the MAP sensor during your install?
Thread
Thread Starter
Forum
Replies
Last Post
s2kcolin
S2000 Under The Hood
6
08-25-2021 03:57 AM
tekka01
California - Southern California S2000 Owners
24
09-11-2009 02:21 PM