Heater Control Diagostic
#1
Registered User
Thread Starter
Heater Control Diagostic
Back story:
Air stuck on cold no matter if knob is turned on hot.
Checked the cable - connected.
Checked fuse 21 in footwell - fine
Checked connection from heater controls to motor that controls the cable into engine bay - all connected
Did the self diagnostic and it illuminates for 2 seconds and then flashes once and repeats to flash every second or so, this continues until I turn of the ignition. The light just blinks and blinks
Any insight as to what to check now?
Air stuck on cold no matter if knob is turned on hot.
Checked the cable - connected.
Checked fuse 21 in footwell - fine
Checked connection from heater controls to motor that controls the cable into engine bay - all connected
Did the self diagnostic and it illuminates for 2 seconds and then flashes once and repeats to flash every second or so, this continues until I turn of the ignition. The light just blinks and blinks
Any insight as to what to check now?
Thread
Thread Starter
Forum
Replies
Last Post