engine swap
03-31-2006, 07:12 PM
#1
Registered User
Thread Starter
Join Date: Mar 2006
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
engine swap
Anyone have any tips on pulling the motor on an S2000? I have hte luxury of a hoist, so dropping it out the bottom won't be an issue.
My question is whether to drop out with the tranny, subframe, etc... Or just to unbolt the engine and lift the engine out. Any tips or suggestion would be greatly appreciated.
I'm a newbie at S2000 and a new owner. Thanks.
My question is whether to drop out with the tranny, subframe, etc... Or just to unbolt the engine and lift the engine out. Any tips or suggestion would be greatly appreciated.
I'm a newbie at S2000 and a new owner. Thanks.
03-31-2006, 08:27 PM
#2
Join Date: Oct 2005
Location: Severn
Posts: 173
Likes: 0
Received 0 Likes
on
0 Posts
I just finished an install like 20 minutes ago!
definately leave everything bolted to the subframe, and drop it from the bottom. theres alot of little shit here and there I dont feel like explaining everything, if you have any specific questions send me a PM, good luck.
definately leave everything bolted to the subframe, and drop it from the bottom. theres alot of little shit here and there I dont feel like explaining everything, if you have any specific questions send me a PM, good luck.
04-01-2006, 06:32 AM
#3
Registered User
Thread Starter
Join Date: Mar 2006
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
I finally "dropped" it today. It wasn't too bad, just a little tricky on getting some of the hoses off. And pulling the harnesses out, etc..
Thanks for the reply. Greatly appreciated.
Thanks for the reply. Greatly appreciated.
Thread
Thread Starter
Forum
Replies
Last Post