engine problems
#12
![Default](https://www.s2ki.com/forums/images/icons/icon1.gif)
well ur gonna have to take seperate ur tranny from ur engine first so u can get to the fly wheel etc... so i would assume taking ur engine out of the bay would be the best thing to do.
#14
Registered User
Thread Starter
Join Date: Apr 2007
Location: Austin TX
Posts: 176
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.s2ki.com/forums/images/icons/icon1.gif)
what kind of pistons should i buy so no sleeving is necessary if i can keep it under 1000 dollars pistons and honing with bearings ill be happy whats the best set up?
#15
![Default](https://www.s2ki.com/forums/images/icons/icon1.gif)
The 2.2 is only stroked so with the 2.2L crank and aftermarket conrods designed to 2.2L specs you are ready to go. Bearing sizes depends on the markings on the block and crank (or actual measurements) and the requirements of the rods.
#16
Registered User
Thread Starter
Join Date: Apr 2007
Location: Austin TX
Posts: 176
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.s2ki.com/forums/images/icons/icon1.gif)
87mm je pistons with acl bearings or stock bearings? take it to a machine shop and get it honed to size of new pistons, assemble it and its good?
#18
Registered User
Thread Starter
Join Date: Apr 2007
Location: Austin TX
Posts: 176
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.s2ki.com/forums/images/icons/icon1.gif)
since the block is apart would you recommend new pistons given i plan on turboing in the near future or are the oem confortably able to reach 350hp with no issues?
also are machine shops responsible for fabricating the rings and bearings or should i just buy atermarket ones to make the engine bulletproof i dont know which rings to buy!
also are machine shops responsible for fabricating the rings and bearings or should i just buy atermarket ones to make the engine bulletproof i dont know which rings to buy!
#19
Registered User
Thread Starter
Join Date: Apr 2007
Location: Austin TX
Posts: 176
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.s2ki.com/forums/images/icons/icon1.gif)
since the block is apart would you recommend new pistons given i plan on turboing in the near future or are the oem confortably able to reach 350hp with no issues?
also are machine shops responsible for fabricating the rings and bearings or should i just buy atermarket ones to make the engine bulletproof i dont know which rings to buy!
also are machine shops responsible for fabricating the rings and bearings or should i just buy atermarket ones to make the engine bulletproof i dont know which rings to buy!
#20
![Default](https://www.s2ki.com/forums/images/icons/icon1.gif)
350!!!
Stock pistons, rings and bearings are more than up to the task.
If you were aiming for over 400 it would be advisable to lower compression and this would be a good argument for new pistons but it opens a whole new kettle of fish. Such as compatibility with FRM.
Stock pistons, rings and bearings are more than up to the task.
If you were aiming for over 400 it would be advisable to lower compression and this would be a good argument for new pistons but it opens a whole new kettle of fish. Such as compatibility with FRM.