Drive-by-wire TPS testing
03-27-2012, 04:42 PM
#1
Registered User
Thread Starter
Drive-by-wire TPS testing
Anyone have instructions on how to test the DBW TPS units for dead spots with a multimeter?
There are 6 wires going into the TPS. I cannot seem to locate a write up or DIY. Any help would be greatly appreciated.
There are 6 wires going into the TPS. I cannot seem to locate a write up or DIY. Any help would be greatly appreciated.
03-27-2012, 05:15 PM
#2
Registered User
Are you getting a TPS CEL?
Here is the only thing I've found when my TPS failed on me.
http://www.8thcivic.com/forums/engin...procedure.html
Here is the only thing I've found when my TPS failed on me.
http://www.8thcivic.com/forums/engin...procedure.html
03-27-2012, 05:45 PM
#3
Registered User
Thread Starter
Are you getting a TPS CEL?
Here is the only thing I've found when my TPS failed on me.
http://www.8thcivic.com/forums/engin...procedure.html
Here is the only thing I've found when my TPS failed on me.
http://www.8thcivic.com/forums/engin...procedure.html
I have a slight jerking on partial throttle. The TPS is basically the only thing left on the car to check. Thanks for the link btw... checking it out now.
Thread
Thread Starter
Forum
Replies
Last Post
ALFYonso
Pacific Northwest S2000 Owners
12
02-11-2011 12:07 PM