Clutch Pedal Sticks
#11
Community Organizer
Thread Starter
Problem fixed!
I thoroughly inspected the master cylinder. No leaks. Checked slave, no leaks again? Followed the service manual instructions and removed the slave cylinder. Greased the slave cylinder boot and rod as instructed and remounted. The seating of the rod into trhe release fork lever took a try or two to get correct. Used finger in 'boot vent holes' to guide into place. Flushed and bleed using XVIPER's (Thanks) Clutch Bleed "How To" guide.
The clutch "stick" is completely gone. The clutch itself seemed to be a bit tighter and the shift was smoother as well. Will need to keep an eye on it as Billman250 indicated. May just be a temp fix.
Thanks to all for your guidance and feedback.
I thoroughly inspected the master cylinder. No leaks. Checked slave, no leaks again? Followed the service manual instructions and removed the slave cylinder. Greased the slave cylinder boot and rod as instructed and remounted. The seating of the rod into trhe release fork lever took a try or two to get correct. Used finger in 'boot vent holes' to guide into place. Flushed and bleed using XVIPER's (Thanks) Clutch Bleed "How To" guide.
The clutch "stick" is completely gone. The clutch itself seemed to be a bit tighter and the shift was smoother as well. Will need to keep an eye on it as Billman250 indicated. May just be a temp fix.
Thanks to all for your guidance and feedback.
Thread
Thread Starter
Forum
Replies
Last Post
laserred02
S2000 Under The Hood
5
11-28-2012 07:12 PM