Car running after money shift!
09-20-2011, 02:34 PM
#1
Registered User
Thread Starter
Join Date: Aug 2011
Posts: 107
Likes: 0
Received 0 Likes
on
0 Posts
Car running after money shift!
Finally after new retainers, locks, valve seals, all new intake and exhaust valves, new exhaust guides, and a valve job car is running!
I had posted before thinking I had my clutch sticking problem fixed. But no. The slave cyl ball was dry and had a nipple. I sanded and greased but still sticks at bottom. Also replaced clutch fluid and adjusted.
I had posted before thinking I had my clutch sticking problem fixed. But no. The slave cyl ball was dry and had a nipple. I sanded and greased but still sticks at bottom. Also replaced clutch fluid and adjusted.
09-20-2011, 02:38 PM
#2
Registered User
Thread Starter
Join Date: Aug 2011
Posts: 107
Likes: 0
Received 0 Likes
on
0 Posts
09-22-2011, 01:07 PM
#6
Registered User
Thread Starter
Join Date: Aug 2011
Posts: 107
Likes: 0
Received 0 Likes
on
0 Posts
Thanks! I looked and found an old post of yours where modfry talked about the slave cylinder. Just didn't make it far enough down to the forks. I'll try that today! Thanks again billman!
Thread
Thread Starter
Forum
Replies
Last Post