run115

Dont know if anyone can help me, I have an EUDM My08 S2000 and just installed an Emanage Ultimate, but the immobiliser is preventing the car from starting. Anyone knows how to remove/bypass the immobiliser?

If need be someone can PM the details please.

Thanks

Vince

negcamber

Did you get the harness for the drive by wire cars?

And I seem to recall a special shut down procedure for the DBW cars so as not to ruin the ECU.

run115

Actually I have wired it in rather than using a bomslang. I didnt know about this procedure, anyone knows anything about this?

jzz30

since the emanage is a piggy back is the immobilizer affected? i would think that you may have a wiring issue rather than the emanage causing problems with the emanage

Enthralled

how did you set your Emanage ultimate? which steps did you take? I was running an Emanage ultimate and followed the directions in a thread on this site. can't remember where I found it, but if you do a search, I'm sure you'll find it. Also, not sure if the Euro cars come with the DBW feature, but if it does, you may need to locate a different harness.

Enthralled

I think this was the thread I went off of.


https://www.s2ki.com/forums/index.php?act=S...post&p=10620440

run115

Thanks for the info guys, will have a good look at it later.