Am I seeing RUST???
#1
Registered User
Thread Starter
Join Date: Jun 2003
Location: Toronto
Posts: 7,076
Likes: 0
Received 0 Likes
on
0 Posts
Am I seeing RUST???
washed my car today... opened up the hood to check for anything abnormal... and i see this!!!
is that screw starting to rust?? I don't know if it came with the car or not... could someone without a struct bar confirm? Should I take that screw out?
I checked the passenger side... there isn't any screw there
please help!
is that screw starting to rust?? I don't know if it came with the car or not... could someone without a struct bar confirm? Should I take that screw out?
I checked the passenger side... there isn't any screw there
please help!
#7
Registered User
Join Date: Feb 2004
Location: SoCal
Posts: 1,140
Likes: 0
Received 0 Likes
on
0 Posts
I usually hit some of my unpainted parts with some silicone spray.
When I raced Dirt bikes that is what we always had to do to prevent rust after a wash. Sprockets, chain, engine, basically any bar metal.
You get the picture.
Be careful... dries out plastic and rubber over time.
When I raced Dirt bikes that is what we always had to do to prevent rust after a wash. Sprockets, chain, engine, basically any bar metal.
You get the picture.
Be careful... dries out plastic and rubber over time.
Trending Topics
#8
Registered User
Join Date: May 2002
Location: Washington State
Posts: 3,178
Likes: 0
Received 0 Likes
on
0 Posts
WTF. It looks to me like you have a washer stuck under the cross brace flange that is what is rusting. Take the cross brace off and see whats going on. There should be no screw there and no washer.
#9
Yes, I dont think there should be anything under the leg of the strut brace. Remove the brace, and remove the obstruction as stated above.
Then wash down the area with car wash soap and warm water. Dry and examine. If no scratches, apply a good coat of wax/Zaino to the affected area. If there are scratches through to the metal, touch up and protect as above. From the pictures, this looks like surface rust only and hasn't started to affect the body. There might, however be scratches from this grommet rubbing on the shock tower with the movement of the car.
As an aside, anyone else have rust on their cars yet? I'm familiar with where most Hondas start to rust, but perhaps some S2000 owners with afflicted cars can point me in the right direction.
Cheers
Asif
Then wash down the area with car wash soap and warm water. Dry and examine. If no scratches, apply a good coat of wax/Zaino to the affected area. If there are scratches through to the metal, touch up and protect as above. From the pictures, this looks like surface rust only and hasn't started to affect the body. There might, however be scratches from this grommet rubbing on the shock tower with the movement of the car.
As an aside, anyone else have rust on their cars yet? I'm familiar with where most Hondas start to rust, but perhaps some S2000 owners with afflicted cars can point me in the right direction.
Cheers
Asif
#10
Registered User
i have rust on the trunk and a little on the fender where it bolts up to the front bumper. When you open the trunk, there are those little round pads and there is rust around one of them. not sure what to do