AEM EMS Tuning - how hard?
#11
Originally Posted by camuman,Apr 24 2008, 10:16 AM
im at about 22 right now from 5k up. when i get some dyno time, i figure i will dial in the af, then start to bump timing and see what happens. what are your af numbers like wiht the 26 degrees of timing? wait, dont you have a dyno somewhere around here?
22 degrees is way too low. You could run 24-25 with zero risk. Just setup your knock sensor and check your plugs for any signs of preignition.
#12
Originally Posted by carrera4,Apr 24 2008, 10:00 PM
If you look at the graph in my sig you can see my AFs although that particular graph for some reason has higher peaks and valleys then most of my runs.
22 degrees is way too low. You could run 24-25 with zero risk. Just setup your knock sensor and check your plugs for any signs of preignition.
22 degrees is way too low. You could run 24-25 with zero risk. Just setup your knock sensor and check your plugs for any signs of preignition.
#13
You know you can compute HP and TQ from your logs and tune that way. There is a maths set for aemlog. You need to use the internal logger and do RPMs on a fast channel. The maths file is on the aem forums.
I just suggest you have a very smooth road that you can do 2nd gear pulls on.
You can also buy a gtech which is a little more accurate.
I just suggest you have a very smooth road that you can do 2nd gear pulls on.
You can also buy a gtech which is a little more accurate.
#14
Originally Posted by carrera4,Apr 24 2008, 10:36 PM
You know you can compute HP and TQ from your logs and tune that way. There is a maths set for aemlog. You need to use the internal logger and do RPMs on a fast channel. The maths file is on the aem forums.
I just suggest you have a very smooth road that you can do 2nd gear pulls on.
You can also buy a gtech which is a little more accurate.
I just suggest you have a very smooth road that you can do 2nd gear pulls on.
You can also buy a gtech which is a little more accurate.
Thread
Thread Starter
Forum
Replies
Last Post
johnR
Archived Member S2000 Classifieds and For Sale
1
07-18-2005 08:05 PM