[DT]

Nice! Can't wait to see it all sorted out (and some new video!)

nt7

Such an awesome build, I'm glad its finnaly comming to a close. Congrats to you.

neuronbob

I am so glad to witness (online, anyway) the final stages of this awesome build.

xyster

Whats wrong with this picture?


ABSOLUTLY NOTHING!!!

CHR!S

is there any way of running a y-pipe to intakes on either side of the car (possibly through ducts in the front bumper)?

xyster

I have thought about it before but there is not much room if any above the radiator so spots to run it are limited.

bradskee

Ballpark figure on how much the whole swap cost?

xyster

All depends on who does it, I did all my own work so it is a lot less exspensive than it would be for some one to pay to have it done. If you did it yourself with a donor car you can look at around 15k (3-5k or so in a donor car, 4k in motor,tranny,ECM and wire harness, 2k in misc. parts, and 3k in a rear end and axles. Or add labor to all that. On mine I went that extra mile and re-ran all S.S. brake lines from front to rear (replacing all hard line not just rubber ones) I also installed a fuel cell and all S.S. -6 fuel lines with AN fittings, along with custom paint, gauges, wing, bay shave, S.S. clutch line, Brake porportioning valve, remote bleeder and more....

S2k-2NV

Damn!!!

xyster

I think i should have your screen name. j/k