Replacing your convertible top with a Robbins Top
#102
Former Moderator
According to their website, there is a distributor in the UK:
European Trimming Company Ltd
7 Amy Road, Oxted
Surrey RH80PX
United Kingdom
Phone: +44(0)01883 718530
Fax: +44(0)01883 716308
http://www.robbinsautotopco.com/dist.html#EUROPE
European Trimming Company Ltd
7 Amy Road, Oxted
Surrey RH80PX
United Kingdom
Phone: +44(0)01883 718530
Fax: +44(0)01883 716308
http://www.robbinsautotopco.com/dist.html#EUROPE
#103
Registered User
Join Date: Jan 2006
Location: Ohio
Posts: 1,113
Likes: 0
Received 0 Likes
on
0 Posts
[QUOTE=carrera0to60,Nov 30 2007, 08:13 AM] I joined the Robbins top club this weekend too!. It took me quite a while to install it but I was doing it by myself and I wanted to make sure everything was prefect so I took my time. The plugs for the back of the roll hoops didn
#107
Originally Posted by negcamber,Dec 31 2007, 09:11 AM
I think you would end up paying pretty close to the same once you factor in shipping from the US. But try Topsonline:
https://www.topsonline.com//index.php?CarmodelID=583
Not sure if they ship international though.
Cabrioworld.com does ship international, however, their prices aren't far off what you were quoted and the shipping would probably make it the same.
https://www.topsonline.com//index.php?CarmodelID=583
Not sure if they ship international though.
Cabrioworld.com does ship international, however, their prices aren't far off what you were quoted and the shipping would probably make it the same.
#109
Just installed the hood, couple of problems though
1. The roof is super super tight. Took alot of pushing to trap it down. Hopefully as it is strapped down it will losen???
2. The roof and door rubbers dont seem to line up. See the picture below??
3.What do you do with the surpluss fabric at the back of the window, shown in pic below??
4. At the back of the window near the main soft top post there is a gap, is this normal??
1. The roof is super super tight. Took alot of pushing to trap it down. Hopefully as it is strapped down it will losen???
2. The roof and door rubbers dont seem to line up. See the picture below??
3.What do you do with the surpluss fabric at the back of the window, shown in pic below??
4. At the back of the window near the main soft top post there is a gap, is this normal??
#110
Registered User
Thread Starter
Originally Posted by S2000JB,Jan 17 2008, 05:56 PM
Just installed the hood, couple of problems though
1. The roof is super super tight. Took alot of pushing to trap it down. Hopefully as it is strapped down it will losen???
2. The roof and door rubbers dont seem to line up. See the picture below??
3.What do you do with the surpluss fabric at the back of the window, shown in pic below??
4. At the back of the window near the main soft top post there is a gap, is this normal??
1. The roof is super super tight. Took alot of pushing to trap it down. Hopefully as it is strapped down it will losen???
2. The roof and door rubbers dont seem to line up. See the picture below??
3.What do you do with the surpluss fabric at the back of the window, shown in pic below??
4. At the back of the window near the main soft top post there is a gap, is this normal??
2. Did you rivet the plastic part of the roof in the right location? Also, make sure you put the chrome trim holders back in the right position. make sure the screws touch where they were touching before. You might want to try loosening the chrome strip and pulling the top out a bit before tightening it back down.
3. Looks like an oversight at the factory. I haven't seen that much excess before, especially in that location. I would just tuck away as much as possible and cut off the rest. They might have revised the design to include that as a temporary pull strap during installation as well.