Installing red 'H'
#31
Originally posted by S2Kguy
The US spec red Honda badges suck, if you want red ones, get the Japanese spec, they are much nicer IMHO.
Andrew
The US spec red Honda badges suck, if you want red ones, get the Japanese spec, they are much nicer IMHO.
Andrew
if they look different, care to post some pics?
#33
Originally posted by NEED4SPEED
The rear skeleton emblems have two plastic prongs in the holes that need to be removed - just push them out. The red emblems fit easily into the holes without the plastic prongs as the two plastic parts on the red emblems are thicker than the skeleton ones. The hardest part is removing the gunk left from the old emblems!
Hope this helps
The rear skeleton emblems have two plastic prongs in the holes that need to be removed - just push them out. The red emblems fit easily into the holes without the plastic prongs as the two plastic parts on the red emblems are thicker than the skeleton ones. The hardest part is removing the gunk left from the old emblems!
Hope this helps
#35
To remove the front badges you need to cut the existing badge pins, they are awkward to get at but try to cut as much of the pin off as is possible (I used some electrical snips), after that its a case of pryingthe badge until it comes, just make sure youve masked the surrounding area and pry away, it may take some force to remove them but they will eventually come.
I found the best way to get the rear off was to use an old credit card and gradually work it under the glue until the badge becomes loose enough to pull off.
Good Luck
I found the best way to get the rear off was to use an old credit card and gradually work it under the glue until the badge becomes loose enough to pull off.
Good Luck
Thread
Thread Starter
Forum
Replies
Last Post