bar under the car by the diff?
#21
Registered User
Originally Posted by DrDre1443,Oct 19 2005, 08:51 PM
Just that aluminum by itself is very malleable.
#22
Registered User
Join Date: Dec 2004
Location: Athens, Greece, Europe, Earth, Universe
Posts: 30,032
Likes: 0
Received 2 Likes
on
2 Posts
I remember when I tried to take it off to remove my exhaust. Very tight or more appropriate, I should say extremely tight! You could hear the bolts "screaming" on every twist when I was trying to remove them, even with the use of penetrating oil.
#23
Originally Posted by cthree,Oct 19 2005, 02:13 AM
Yeah, the cusco uses faster steel, adds a good 10HP they say
It adds a good 15 R.W.H.P.!!!
#24
Registered User
the comptech one is nice!
I put the red one on my GSR. It wasn't one of those cheap ones that just go over the lower control arm bolts (which is bad as it puts shearing forces in a completely different vector on BOTH bolt heads). The Comptech one had 4 bolts on the mounts on each side that you attached to the subframe...if you've seen the ITR's bar it mimics that. It was very obvious yet very understated.
anyway, I want one for my S2000.
I put the red one on my GSR. It wasn't one of those cheap ones that just go over the lower control arm bolts (which is bad as it puts shearing forces in a completely different vector on BOTH bolt heads). The Comptech one had 4 bolts on the mounts on each side that you attached to the subframe...if you've seen the ITR's bar it mimics that. It was very obvious yet very understated.
anyway, I want one for my S2000.
Thread
Thread Starter
Forum
Replies
Last Post