RSG Bar track guys Group buy ONLY $580 WHILE SUPPLIES LAST! ENDS 9/15
#41
Thanks Driven for the info.
On a side note, I'll be in Vegas for 3 days starting tomorrow for a dental convention...not fun when you gotta be up at 7am...lol
On a side note, I'll be in Vegas for 3 days starting tomorrow for a dental convention...not fun when you gotta be up at 7am...lol
#42
Thread Starter
when you reinstall the ctr box.. it rest on the ctr flat metal bracket that the seatbelt retractors bolt to. there is no reason to actually bolt this down anywhere other than the 2 screws in the front that sit under your elbow rest pad.
there are a few people that run the ctr box without anything supporting it, and its fine.
The main reason for the bulkhead replacement bar is to enable the use of both the factory belts at the same time as harnesses. you CANNOT run harnesses with a stock bulkhead mounted because the bulkhead sits a lot higher. besides that, it makes everything a little nicer looking back there and everything fits easier.
there are a few people that run the ctr box without anything supporting it, and its fine.
The main reason for the bulkhead replacement bar is to enable the use of both the factory belts at the same time as harnesses. you CANNOT run harnesses with a stock bulkhead mounted because the bulkhead sits a lot higher. besides that, it makes everything a little nicer looking back there and everything fits easier.
#43
Thread Starter
few more days till this group buy is over. dont miss out on the special pricing!!! must have submitted payment on or before the end date to get this pricing.
#46
Thread Starter
$520 was the price for the first 5 that signed up. People were waiting until we hit our quota to get back to that price. Were no where near that number. You won't even find used bars at these prices.
Get your spot. Only a few days left. The 16th, were back at full price.
Get your spot. Only a few days left. The 16th, were back at full price.
#48
shipment date?
#50
Fitment is good on mine. Millimeters of clearance for top up and top down. I can snap a pic if you were interested in something specific. Only fitment issue I had was 1 bolt would not go in on the BH bar. I could elongate the hole if I cared...