GROUP BUY: Go Fast Lab Roll Bars
#392
Registered User
Originally Posted by Slows2k,Oct 8 2006, 04:40 PM
Did you drive the car with a wheel speed sensor unplugged?
If you plug it back in, a short time of driving could clear the faults.
Or you could just have somebody read the code.
#394
I hope somebody is reading this that can provide quick help.
I'm in the process of putting the bar in place and bolting it down. The thing I can't figure out is if I'm supposed to leave out the corner gussets that bolt to the bulkhead behind the seats, and to the tub on the sides.
It doesn't seem possible to have them in before placing the bar, or to put them in afterward. I'd appreciate any advice on this.
Thanks.
I'm in the process of putting the bar in place and bolting it down. The thing I can't figure out is if I'm supposed to leave out the corner gussets that bolt to the bulkhead behind the seats, and to the tub on the sides.
It doesn't seem possible to have them in before placing the bar, or to put them in afterward. I'd appreciate any advice on this.
Thanks.
#397
Registered User
Are the clearance issues with the seatbelt module installed on the rollhoop or the rollhoop itself? Haven't started install yet, but am considering reinstalling the rollhoop without the stock seatbelt components. Intending to use harness only.
also, please put me on the list for the clamps.
also, please put me on the list for the clamps.
#399
Registered User
Thread Starter
Join Date: Jul 2001
Location: Anaheim, Orange County
Posts: 8,754
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Clark,Oct 9 2006, 03:59 PM
I hope somebody is reading this that can provide quick help.
I'm in the process of putting the bar in place and bolting it down. The thing I can't figure out is if I'm supposed to leave out the corner gussets that bolt to the bulkhead behind the seats, and to the tub on the sides.
It doesn't seem possible to have them in before placing the bar, or to put them in afterward. I'd appreciate any advice on this.
Thanks.
I'm in the process of putting the bar in place and bolting it down. The thing I can't figure out is if I'm supposed to leave out the corner gussets that bolt to the bulkhead behind the seats, and to the tub on the sides.
It doesn't seem possible to have them in before placing the bar, or to put them in afterward. I'd appreciate any advice on this.
Thanks.