Slows2k

Did you drive the car with a wheel speed sensor unplugged?

mikegarrison

That's what it sounds like to me. Sometime during the install you unplugged a connector.

If you plug it back in, a short time of driving could clear the faults.

Or you could just have somebody read the code.

1_slow_s2000

yeah.. i did jus tthat. drove it and it went away. the code must have been from when i had the key in ignition with plug disconnected.

Clark

I hope somebody is reading this that can provide quick help.

I'm in the process of putting the bar in place and bolting it down. The thing I can't figure out is if I'm supposed to leave out the corner gussets that bolt to the bulkhead behind the seats, and to the tub on the sides.

It doesn't seem possible to have them in before placing the bar, or to put them in afterward. I'd appreciate any advice on this.

Thanks.

Slows2k

You leave the corner gussets out. No room for them anymore.

Clark

Thanks for the confirmation Slows2k.

eepr5

Are the clearance issues with the seatbelt module installed on the rollhoop or the rollhoop itself? Haven't started install yet, but am considering reinstalling the rollhoop without the stock seatbelt components. Intending to use harness only.


also, please put me on the list for the clamps.

SC_Highlander

Just the bracket that the seatbelt guide bolts to.

Asura

By the time you trim the corner gusset it will be too flimsy to put back since you would have to cut out the center section of it, almost where the rain gutter is.

Slows2k

My bar has been returned and the DVD is on the way to GFL