sub-frame bolt question
#1
Registered User
Thread Starter
sub-frame bolt question
I'm thinking of using this bolt for a hanger for my rear diffuser...
anyone think of a reason i shouldn't?
i would be making the hanger out of aluminum bar stock so it would in effect be an aluminum washer...
almost concerns me -- but I'm just not sure.
here is a pic.
any thoughts?
anyone think of a reason i shouldn't?
i would be making the hanger out of aluminum bar stock so it would in effect be an aluminum washer...
almost concerns me -- but I'm just not sure.
here is a pic.
any thoughts?
#5
Registered User
Thread Starter
Originally Posted by osidis,Nov 28 2010, 01:57 PM
there should be a general spec for that size. 10mm is about 35in to 45in lbs. 12mm is around 55-75 in lbs and 14mm is 85-95. unless its threaded into aluminium. its about half.
thanks.
Thread
Thread Starter
Forum
Replies
Last Post