Holeshot121

I recently installed a RSG single diagonal roll bar with bulkhead bar. I'm using stock seats and belts. The way the seat belts rub against the inside of the roll bar and then through the guides on the seat, there is enough friction that they don't retract without a little help. Is this typical? It doesn't really bother me. I just want to make sure I installed and routed everything correctly.

ISADE

Route it on the outside of that bar, I did it the same way you did at first and had the same issue, put it to the outside and it should retract easier.

Holeshot121

I was wondering about that but it looked kinda strange going that far outboard with them.. lol. Thanks!

Chibo

This is an issue with pretty much every NASA legal bar.