Official Enkei RPF1 Thread
#4111
Originally Posted by BanzaiS2K2003,May 26 2010, 03:51 AM
how much front camber can u get away with if you have a 17x9 45 front and a 225/45 tire? no fender pulling of rolling involved.
#4113
let put it this way my front fender is 24" off the ground and the rear is 25" from the ground and my camber setting is at 1.5 front and 2.25 rear
no rubbing and it looks perfect..i can go lower but it wouldnt be practial from my daily route
no rubbing and it looks perfect..i can go lower but it wouldnt be practial from my daily route
#4114
Originally Posted by BanzaiS2K2003,May 26 2010, 06:45 AM
Im on coils so let's say abou 1.5 to 2 inch drop. I wanna get rid of my wheel gap. Is
-1.8 be enough?
-1.8 be enough?
For reference, I’m on a 2" drop, about 1 finger gap. I run the 8.5 +40 with 225/45 with -2.2 and I am rubbing some with rolled fenders. I am going in for another alignment to adjust camber. Likely -2.5-8 ish. Your 9" +45 stick out a few mm more then mine.
#4115
Originally Posted by Thanhstar,May 24 2010, 02:39 PM
New photos
this is my car now
thanks for all the input!!
#4116
Can someone do me a huge favor? I just bought a new set of brakes and they don't fit under my 17x9 +45 RPF1's. I need someone to measure the brake clearance on their 17x8.5 RPF1's. Just stick a ruler up against the caliper and tell me how far away the spokes are and the offset of your wheels.
TIA
Pete
TIA
Pete
#4118
Originally Posted by [AP2-2NV
,May 27 2010, 03:32 AM] Whatever brakes they are they'll probably clear.
Someone has a 8+45 with stoptechs. Anything under 9" has a convex face, massive bbk room
Someone has a 8+45 with stoptechs. Anything under 9" has a convex face, massive bbk room
Pete
#4119
Yea maybe someone else has some more info. I think the only think bigger than stoptech is endless. And I would imagine an 8.5 having more clearance than the 8. Especially considering the 8.5 doesn't come in a +45. So if you have the 8.5+40 that's an extra 5mm too. I really don't see why it wouldn't fit