Official Enkei RPF1 Thread
#1101
Originally Posted by Integra21,Nov 18 2008, 07:29 PM
CENTER CAPS!!!!!
someone help!!!!!!
someone help!!!!!!
They're from an accord. I'll get a pic and/or part number when I get the chance.
#1102
Originally Posted by nitewing117,Nov 19 2008, 07:00 AM
I have a set of caps that fit. They're not flush completely, but they fit. I'm not sure if you have a flush cap on the rear anyways.
They're from an accord. I'll get a pic and/or part number when I get the chance.
They're from an accord. I'll get a pic and/or part number when I get the chance.
#1103
They're from a Honda Accord (part # 44732-S9A-AOO) and all I had to do was sand down the inside of the caps for 2 of them.
The fronts fit no problem, but I had to sand the rears so they would go over the rear nut.
I posted this in the Ohio Owner's Section (Ohio Owner's Rides) and in the
Wheel Forum (RPF1 Center Caps) a while back.
#1108
FYI the part number is 44732-S9A-A00.
last two being zero's not "O"'s
$22.37 each though
http://www.hondaautomotiveparts.com/auto/j...+VIN+Number+---
last two being zero's not "O"'s
$22.37 each though
http://www.hondaautomotiveparts.com/auto/j...+VIN+Number+---
#1109
Originally Posted by Integra21,Nov 19 2008, 05:15 PM
FYI the part number is 44732-S9A-A00.
last two being zero's not "O"'s
$22.37 each though
http://www.hondaautomotiveparts.com/auto/j...+VIN+Number+---
last two being zero's not "O"'s
$22.37 each though
http://www.hondaautomotiveparts.com/auto/j...+VIN+Number+---
#1110
yea true but thats about what the actual RPF1 caps cost. at least these ones look good!!
Im thinking of doing it; black with a red H? or all black???
anyone have any detail of the "trimming" needed to fit the rear? The caps say they are aluminum, but are the clips as well?
Im thinking of doing it; black with a red H? or all black???
anyone have any detail of the "trimming" needed to fit the rear? The caps say they are aluminum, but are the clips as well?