JimSUPERFLY

You need a new impeller dude.


Sent from my iPhone using Tapatalk

SeanGPW

Subscribed! I don't think I need to rebuild just yet but I wouldn't mind having an idea on what to do!

E4RTH WORM JIM

Try it without heat as per jim superflys post. I will be amazed if you get it off though, so have a go and report back. Hopefully yours will come off.

If you speak with Paxton (and read on the net) you will find they heat the components before fitting as per my post.

Good luck

E4RTH WORM JIM

Have a look here

Note the blow torch and glove in the second picture.

I only used a press for the output shaft seal. Everything was done using themal practices (Torch, oven and a bearing induction heater).

http://www.mustangandfords.com/how-t...sassembly.html

JimSUPERFLY

Saw that!
Good read. Thanks.
It is removable without heat. Did mine twice, no worries.


Sent from my iPhone using Tapatalk

E4RTH WORM JIM

Good to know

Did you damage the impeller seal when removing the impeller?

JimSUPERFLY

No damage to the seal.

Heat definitely simplifies the impeller and output shaft removal. I'll try it next time.


Sent from my iPhone using Tapatalk

aj_shortman

heats no problem, got an oxy at work, just wondering how far i have to go to get the impeller off, any more photos?

aj_shortman

also does the impeller need to be balanced after install?