oil pressure sender unit

Reply Subscribe

Thread Tools

12-27-2008, 09:28 AM

#11

SPECIAL-OPS-S2K

Registered User

Join Date: Feb 2007

Location: Lincoln, NE

Posts: 1,923

Likes: 0

Received 1 Like on 1 Post

i hope you didn't thread that brass T into your the stock sensor position... that is alot of weight for that spot to support with all the vibrations of the engine and such...

Reply Like

12-27-2008, 04:43 PM

#12

jwa4378

Join Date: May 2005

Location: Tallahassee, FL

Posts: 4,331

Likes: 0

Received 0 Likes on 0 Posts

^My T fitting is installed directly to the block. No problems thus far.

I have read about a few cracking, but I think that was due to the design of the ones used... My fitting is much more rounded and beefier looking than the pics of the broken one I saw (the one I saw broken was a standard hex shaped one)...

Also, if a BSPT--->MPT adapter is not used (almost no T fittings are BSPT... at least none I have found in any local shops), I think that would cause extra vibrations/problems, as it would be in there much tighter than it would be if the proper fitting where used (pressure points on the threads from the improper thread pattern)...

John

Reply Like

12-30-2008, 04:56 PM

#13

ChefJ

Registered User

Join Date: May 2006

Location: Braselton, GA

Posts: 7,659

Likes: 16

Received 3 Likes on 3 Posts

Quote:

Originally Posted by chinookpilot1' date='Dec 27 2008, 09:00 AM

I installed an oil pressure gauge and kept the light as well. I went to a hardware store and got the correct brass t-fitting and redusers. It looks good and there are no oil leaks. If the car came with the oil light then why not keep it as a backup to the gauge.

Because if that little light comes on its to late anyway. You should run a braided line to the sender as opposed to installing the sender to the block.