New FB340 Intank Fuel Pump
04-08-2011 | 07:47 PM
#11
Joined: Dec 2007
Posts: 2,274
Likes: 5
From: Midwest
For that power level you can run just a walbro. I would upgrade to this pump because it is quiet! Once you make the switch you will never go back to a walbro trust me.
04-08-2011 | 07:51 PM
#12
Thread Starter
Former Sponsor
Joined: Nov 2008
Posts: 727
Likes: 0
This pump on 1600cc injectors will do about 600hp. The higher the flow rating of the pump the lower the injector duty cycle will be up to a certain point. The good thing about our pump is that it can handle high pressures and still perform.
04-08-2011 | 08:04 PM
#14
Thread Starter
Former Sponsor
Joined: Nov 2008
Posts: 727
Likes: 0
Kenneth, these flows just the same comparing to aeromotive's personal tests. We really wanted a third party to flow these so everyone knows that we did not fudge these numbers. I was going to tell you about these pumps,but I don't like to release things till we know 110% that it is what it is. Let me know if you have any questions buddy. LJ
04-08-2011 | 08:16 PM
#15
Registered User
Joined: Nov 2009
Posts: 2,035
Likes: 1
From: McKinney, TX
LJ, can you answer my question, specific to my setup? I will buy one of these if it will work.
04-08-2011 | 08:20 PM
#16
Thread Starter
Former Sponsor
Joined: Nov 2008
Posts: 727
Likes: 0
LJ, can you answer my question, specific to my setup? I will buy one of these if it will work.
Originally Posted by jaundice' timestamp='1302320275' post='20446761
So, can I run 1 FB340 and E85, or will I still need the dual setup? I am only planning to make about 400hp on a stroker motor with SOT roots supercharger. I have an IP fuel rail, ID1000's, and an adjustable FPR already.
04-08-2011 | 08:48 PM
#20
Registered User
Joined: Nov 2009
Posts: 2,035
Likes: 1
From: McKinney, TX