Jim'z Vortech V3 build *Questions*
#1
Jim'z Vortech V3 build *Questions*
I just purchased a Vortech V3 s/c with an Ultimate Racing intercooler and Tial blow-off.
I have a 4.25" pulley right now.
From what I read a 4" pulley should provide +/- 10 psi on AP2 (stock rev limiter). Correct?
I'm looking for 9 psi passed the intercooler.
Where can I buy a 4" pulley and belt?
What are your thoughts on fuel pressure regulating? Needed or not?
Any info and input is appreciated since I'm new to the f/i dark side.
Cheers
Sent from my iPhone using Tapatalk
I have a 4.25" pulley right now.
From what I read a 4" pulley should provide +/- 10 psi on AP2 (stock rev limiter). Correct?
I'm looking for 9 psi passed the intercooler.
Where can I buy a 4" pulley and belt?
What are your thoughts on fuel pressure regulating? Needed or not?
Any info and input is appreciated since I'm new to the f/i dark side.
Cheers
Sent from my iPhone using Tapatalk
#2
ASP in Texas makes pulleys. 1-877-928-6878
Get your belt size here: https://www.s2ki.com/s2000/topic/254...ry-belt-sizes/
4060500 works with the 4 inch pulley.
Get your belt size here: https://www.s2ki.com/s2000/topic/254...ry-belt-sizes/
4060500 works with the 4 inch pulley.
#4
I just purchased a v3 as well.
Had to send it in since the oil slinger was mangled.
My setup
V3 with 3.8" on ap1. Est 13-14psi
Id1000's
Upgraded fuel pump
Stock aftercooler setup
No fuel pressure regulator. Looking to get it tuned within the next two week.
Had to send it in since the oil slinger was mangled.
My setup
V3 with 3.8" on ap1. Est 13-14psi
Id1000's
Upgraded fuel pump
Stock aftercooler setup
No fuel pressure regulator. Looking to get it tuned within the next two week.